Dual-Form Nail Extension Mistakes and Correct Practices

Dual-form nail extension is a technique that offers durable and aesthetic results when applied correctly. However, mistakes made in this technique both reduce the quality of the application and negatively affect its permanence. Here are common mistakes in dual-form nail extension and ingenious tips to avoid them:

Wrong Nail Preparation

Pterygium Removal: Pterygium is located as a thin layer on the cuticle. When this area is not cleaned, the material cannot fit properly on the surface and adhesion problems occur.

Correct Manicure: Pterygium should be carefully cleaned and the nail surface should be prepared with a careful manicure. In this way, the application will be more durable and problems such as lifting will be prevented.

Wrong Form Selection

Form Selection According to Nail Shape: The natural structure of the nail is a determining factor in choosing the form. A slightly curved form should be preferred for straight nails and a more curved form for downward sloping nails.

Tips for Adjusting the Curve of the Form: Bending the form slightly before placing it on the finger will create a curve that matches the natural nail structure and will provide an aesthetic appearance.

Wrong Amount of Material

Adequate Material Use in the Stress Zone: The stress zone is the part of the nail that is most exposed to pressure. If not enough material is applied to this area, the nail may break.

Thinness Control: A thin layer of material should be used in the cuticle and side areas, and a thicker layer should be used in the middle area to ensure durability.

Wrong Application Technique

Concentrating Material in the Center: A balanced look is achieved by leaving a dense layer in the center of the nail and a thinner layer on the sides.

Correct Brush Usage: By using the flat part of the brush, the material should be spread evenly, thus achieving a more aesthetic result.

Applying Too Much Pressure

Placing the form gently: It is important to place the form without excessive pressure on the nail. Too much pressure can cause the material to overflow from the sides and cause breakage.

Pressure Control: The form should be placed gently and controlled by pressing lightly on the finger.

Material Leaks

Cleaning Leaks: Any material that overflows from the edges of the form should be cleaned with an orange stick or brush. Otherwise, these leaks can lead to nail lifting problems.

Air Bubbles

Correct Form Curl: Air bubbles can form when the form does not fit the nail properly. Therefore, choosing the right form is very important.

Fighting Bubbles: Any air bubbles should be removed with a carbide-tipped file and filled with acrygel.

Wrong Form Angle

Side Angle Control: Placing the form at the wrong angle distorts the natural appearance of the nails. The form should be placed in line with the nail growth lines.

Ensuring Correct Angle: A proper angle adjustment should be made by paying attention to the lower nail parallels.

Material Correction on the Inside

Editing the Inner Surface After Form Placement: After the form is placed, irregularities on the inside of the nail should be corrected with a brush. This requires less filling.

Smoothing with Brush: The material is spread smoothly with light touches of the brush.

Excessive filing in the cuticle area

Precision filing: Over-filing can thin the nail surface and lead to peeling. Filing should only be done just enough to achieve a transition.

Attention to Material Thinning: Excessive thinning weakens the durability of the nail. Therefore, care should be taken during the filing process.

In summary, dual-form nail extensions offer durable and stylish results when the right techniques are applied. By paying attention to the above suggestions, you can increase the durability of the application and achieve aesthetic results.